Below is a sample plan that can be followed to build the prerequisite strength. These sessions take into account that you are performing upper-body pulling and upper-body pushing movements throughout the week in your regular workouts. The sessions are intended to be short and consist of 1 pull-up-focused session and 1 ring dip-focused session per week and can be performed before or after your normal workout. Developing the strength necessary for a muscle-up may take months, even years. Be patient and consistent!
\n
Why Negatives?
\n
The term “negative” typically refers to the eccentric phase of a movement. Examples of the eccentric phase of a movement are the lowering phases of a squat, bench press, pull-up, dip, etc. Considering that most athletes are already doing a fair amount of fast-paced efforts during their normal workouts, doing some eccentric-focused efforts can provide a different means to develop strength for pull-ups and dips. The volume should be low — no more than 10 total reps in a session — with a focus on control throughout the entire range of motion.
\n
Optional Accessory Work
\n
Accessory movements are typically done after the main section of a workout to target specific muscle groups or a specific skill. To develop pull-ups and dips, a low dose of accessory work can be introduced with the goal of targeting upper-body pulling and pressing strength. Keep in mind, if this additional work takes away from your main sessions, or if time is an issue, this work can be removed altogether.
\n
Weekly Overview
\n
Session 1: Pull-up Focus (One time per week)
\n
Phase 1- Negatives
\n
5-7 sets of 1 negative pull-up (on bar or rings) \n*Rest 2-4 minutes between sets.
\n
Notes:
\n
\n
Each rep is intended to be a maximum effort.
\n
Attempt to hold at the top for 8-10 seconds before lowering under control.
\n
The goal is to increase the time under tension for a single rep from week to week.
\n
Scale this movement by using a band or by performing a “toe-nail assisted” variation.
\n
\n
Phase 2 – Strict Pull-ups
\n
When you have developed the capacity for strict pull-ups, remove the focused negatives and replace with 3-5 sets of 3-5 reps of strict pull-ups while resting 2-3 minutes between sets.
When 3 sets of 5 strict pull-ups are achievable, add load or progress to reps on the rings while maintaining a false grip.
\n
\n
Optional Accessory Work
\n
Variations of the pull-up and vertical pulling strength will be the main focus for development. Pick one of the options in this video and complete 2-3 sets for 10-12 challenging repetitions while resting approximately 1-2 minutes between sets. If you want some variance, you can pick a horizontal pulling movement like a ring row or single-arm dumbbell row and perform them in a similar fashion
\n
Session 2 – Ring Dip Focus (One time per week)
\n
Phase 1 – Negatives
\n
5-7 sets of 1 negative ring dip \n*Rest 2-4 minutes between sets.
\n
Notes:
\n
\n
Each rep is intended to be a maximum effort without exceeding 30 seconds.
\n
Do not hold at the top for more than 8-10 seconds before lowering.
\n
The goal is to increase the time under tension for a single rep from week to week.
\n
Scale this movement by completing a banded variation or performing a “toe-nail assisted” variation.
\n
\n
Phase 2 – Strict Ring Dips
\n
Similar to the pull-up, when you have developed the capacity for strict ring dips, remove the focused negatives and replace with 3-5 sets of 3-5 reps of strict dips, resting 2-3 minutes between sets.
When 3 sets of 5 strict dips are achievable, perform reps with a 1-2-second pause in the bottom position.
\n
\n
Optional Accessory Work
\n
Variations of the ring dip that provide a challenge will be the priority when building strength and range of motion for this movement. Options include band-assisted ring dips, box dips, and toe-nail assisted dips on the rings, etc. Performing 2-3 sets of 8-12 reps while resting 1-2 minutes between sets will be sufficient. If looking for a change of pace, horizontal pressing movements like the dumbbell bench press, barbell bench press, and deficit push-up can be performed in a similar fashion.
\n
Auto-Regulate
\n
Come into the week with a plan of attack but feel free to alter the extra work as you see fit. If you notice a decrease in recovery, decreased performance, and/or decreased motivation in your normal workouts, eliminate the accessory exercises (if performing them) or reduce the extra sessions to one day per week. In contrast, if you are recovering well and your performance is good, feel free to add another low-volume session focusing on muscle-up skill development.
Part 1 \n5 sets: \n1 rep of a max-seconds negative pull-up \n*Do not exceed 30 seconds.
\n
Optional – Part 2 \n2 sets: \n10/10 single-arm dumbbell rows
\n
Ring Dip Session
\n
Part 1 \n5 sets: \n1 rep of a 10-15 second negative ring dip \n*Do not exceed 30 seconds.
\n
Optional – Part 2 \n2 sets: \n10 dumbbell bench presses
\n
Week 2
\n
Pull-up Session
\n
Part 1 \n5 sets: \n1 rep of max-seconds negative pull-up \n*Beat last week.
\n
Optional – Part 2
\n
2 sets: \n10/10 single-arm dumbbell rows \n*Increase load from last week.
\n
Ring Dip Session
\n
Part 1 \n5 sets: \n1 rep of max-seconds negative ring dip \n*Beat last week.
\n
Optional – Part 2 \n2 sets: \n10 dumbbell bench presses \n*Increase load from last week.
\n
Week 3
\n
Pull-up Session
\n
Part 1 \n5 sets: \n1 rep of max-seconds negative pull-up \n*Beat last week.
\n
Optional – Part 2 \n2 sets: \n10/10 single-arm dumbbell rows \n*Increase load from last week.
\n
Ring Dip Session
\n
Part 1 \n5 sets: \n1 rep of max-seconds negative ring dip \n*Beat last week.
\n
Optional – Part 2 \n2 sets: \n10 dumbbell bench presses \n*Increase load from last week.
\n
Week 4- Deload
\n
Pull-up Session
\n
3 sets: \n5 strict pull-ups \n*Use scaling variation that is moderately challenging for 5 reps.
\n
Ring Dip Session
\n
3 sets: \n5 strict ring dips \n*Use scaling variation that is challenging for 5 reps.
\n
Notes:
\n
Weeks 5-7 can continue with the negatives or move to Phase 2 (outlined above) and perform strict pull-ups and/or dips if capacity has been developed. For the accessory movement, (if utilized) change the exercise and progress in a similar fashion as Weeks 1-3. This strategy can be repeated until goals have been reached.
As you may have noticed, the ability to perform pull-ups and dips does not mean you will be able to do a muscle-up. Having the contractile potential to do a muscle-up is only one piece of the puzzle. The other piece is practicing the skill to garner neurological adaptations and largely revolves around establishing the false grip and focusing on the transition phase to be able to productively apply force. Start by educating yourself on the mechanics of the muscle-up and practicing drills at a level that challenges you.
\n
\n
The following resources are invaluable tools for learning the technical elements of the movement and provide a wide array of drills you can implement regardless of your current capacity. Complete two to three sessions each week where you spend 10-15 minutes working on a drill challenging relative to your ability level. Allow yourself one to three attempts at the muscle-up each week and video your efforts.
For quality: \nAccumulate 10 lower-body assisted muscle-ups on low rings
\n
Day 2
\n
Part 1 \n2 sets: \n3-5 strict ring pull-ups with false grip
\n
Part 2
\n
2 sets: \n5 ring transitions (feet on floor) + dip
\n
Day 3
\n
Optional – 3 attempts at a ring muscle-up
\n
For quality: \nAccumulate 10 banded muscle-ups on low rings \n*Band attached to rings and placed below the hips
\n
Week 2
\n
Day 1
\n
For quality:
\n
Accumulate 12 lower-body assisted muscle-ups on low rings.
\n
Day 2
\n
Part 1
\n
2 sets: \n3-5 strict ring pull-ups with false grip
\n
Part 2
\n
2 sets: \n6 ring transitions (feet on floor) + dip
\n
Day 3
\n
Optional – 3 attempts at a ring muscle-up
\n
For quality: \nAccumulate 12 banded muscle-ups on low rings \n*Band attached to rings and placed below the hips
\n
Week 3
\n
Day 1
\n
For quality: \nAccumulate 15 lower-body assisted muscle-ups on low rings
\n
Day 2
\n
Part 1 \n3 sets: \n3-5 strict ring pull-ups with false grip
\n
Part 2 \n3 sets: \n5 ring transitions (feet on floor) + dip
\n
Day 3
\n
Optional – 3 attempts at a ring muscle-up
\n
For quality: \nAccumulate 15 banded muscle-ups on low rings \n*Band attached to rings and placed below the hips
\n
Notes:
\n
Rest as needed between efforts. After completion of the three weeks, use a similar template while increasing difficulty.
\n
For example:
\n
For Day 1, use a more challenging body position by placing the feet further in front of the rings, straightening the legs, or raising the rings slightly.
\n
For Day 3, increase the difficulty by using a lighter banded tension or utilize a more challenging placement of the band.
\n
Final Note:
\n
Remember, consistency with this program is critical for achieving a muscle-up. Progress may be slow and may happen in unpredictable spurts. The best strategy is to be patient, work the drills consistently, and enjoy the process!
\n
Stay tuned to a future article on the next step after achieving the muscle-up: refining the skill and linking reps together.
Matthieu Dubreucq is a Seminar Staff Flowmaster for CrossFit’s Education Department and owner of CrossFit Laval since 2008, now hosted by Matt’s Garage Training Club. He is a Certified CrossFit Coach (CF-L4), former Canadian Sailing Team athlete, Canadian Ski Alliance Level 3 Ski Instructor, and Canadian Yachting Association Level 4 Coach. He is a published kid’s book author (2012),“Let’s Run, Allons Courir,” and in July 2024, he will publish his first nonfiction book co-authored with Christopher Dedeyan,“Play For Profit.”
We use cookies to improve your experience on our site and to allow us and third parties to personalize the ads and marketing content you see on other websites and social media. For more information, see our cookie notice.